2. Getting involved
3. Standards Committees
4. NMP

DIN Standards Committee Materials Testing

Overview

This part of EN 28510 specifies a 90° peel test for the determination, under specified conditions, of the peel resistance of a bonded assembly of two adherends where at least one adherend is flexible. If a normal tensile testing machine is used for the test, the peel angle will not be constant at exactly 90°. If a constant angle of exactly 90° is required, a roller peeling device is used. The 90° peel test is particularly suitable for use with less flexible adherends for which a 180° peel test is not suitable because the adherends crack, break or delaminate. A 180° peel test is described in EN ISO 8510-2. A bonded assembly of two adherends is prepared using the adhesive under test. The adherends are then pulled apart at a substantially steady rate, starting at the open end of the bond, in such a way that separation occurs progressively along the length of the bonded adherends. The force is applied approximately normal to the plane of the bond, through the separated part of the flexible adherend. The responsible committee is NA 062-10-02 AA "Prüfung von Konstruktionsklebstoffen, -klebverbindungen und Kernverbunden" ("Testing of structural adhesives, structural adhesive bondings and sandwiches") at DIN.

Document: references other documents

Responsible national committee

NA 062-10-02 AA - Test methods relevant to structural adhesive technology  

Responsible european committee

CEN/TC 193/WG 2 - Structural adhesives