NA 062

DIN Standards Committee Materials Testing

Standards [Withdrawn]

DIN ISO 7743
Rubber, vulcanized or thermoplastic - Determination of compression stress-strain properties (ISO 7743:2011)

Title (German)

Elastomere oder thermoplastische Elastomere - Bestimmung des Druckverformungs-Verhaltens (ISO 7743:2011)

Overview

This document contains the German translation of International Standard ISO 7743:2011, which has been prepared by Technical Committee ISO/TC 45 "Rubber and rubber products" (secretariat: DSM, Malaysia). The responsible national committee is NA 062-04-34 AA "Prüfung der physikalischen Eigenschaften von Kautschuk und Elastomeren" ("Test procedures for physical properties of rubber") at DIN Standards Committee Materials Testing (NMP). This International Standard specifies methods for the determination of the compression stress-strain properties of vulcanized or thermoplastic rubber using a standard test piece, a product or a part of a product. Four procedures are given. The four procedures do not give the same results. Method A (test piece A, lubricated) gives results which are dependent only on the modulus of the rubber and are independent of the test piece shape, provided that complete slip conditions are achieved. Effective lubrication is sometimes difficult to achieve, however, and it is prudent to inspect the variance in the test results from replicate test pieces for indications of erratic slip conditions. Method B (test piece A, bonded) gives results which are dependent on both the modulus of the rubber and the test piece shape. The dependence on test piece shape is strong and consequently the results are markedly different from those obtained with lubricated test pieces. Method C (test piece B) gives results which are independent of both the test piece shape and the lubrication conditions. This test piece is more appropriate and more convenient when intrinsic material properties are to be determined. For products (method D), the result is dependent on the shape, but as tests on products are mainly comparative this is acceptable. Provision is made for the use of test pieces of different size and/or shape from the specified test pieces, but extrapolation of the results obtained to other sizes and shapes can prove impossible. The method is not suitable for materials that exhibit high set.

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 062-04-34 AA - Test procedures for physical properties of rubber  

Edition 2016-08
Original language German
Translation English
Price from 91.80 €
Table of contents

Contact

Daniel Müller

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2867
Fax: +49 30 2601-42867

Send message to contact