Overview

This document addresses ultrasonic test systems implementing array probes, for contact technique (with or without wedge) or for immersion technique, with centre frequencies in the range of 0,5 MHz to 10 MHz. This document provides methods and acceptance criteria for determining the compliance of the complete system. Its purpose is for the verification of the correct operation of the system prior to testing or verification of the absence of degradation of the system. The methods are not intended to prove the suitability of the system for particular applications but are intended to prove the capability of the complete system (used for an application) to operate correctly according to the settings used. Tests can be performed on individual ultrasonic beams (for phased array technique) or on resulting images (for phased array technique and total focusing technique). The tests can be limited to the functions that are intended to be used for a certain application. This document does not cover the sensitivity setting of the system for a specific application. Nor does it apply to the characterization or verification of the mechanical scanning equipment. It is intended that these items will be covered by the test procedure. This document does not address the phased array technique using tandem technique. The characterization of beams, as recommended in case of dead elements or for more in-depth knowledge of the beams, is presented in Annex A. It is not applicable for signal processing technology using arrays. The responsible German standardization committee is Working Committee NA 062-08-23 AA "Ultraschallprüfung" ("Ultrasonic testing") at DIN Standards Committee Materials Testing (NMP).

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 062-11-12 AA - Ultrasonic testing  

Responsible european committee

CEN/TC 138/WG 2 - Ultrasonic testing  

Responsible international committee

ISO/TC 135/SC 3/WG 5 - Ultrasonic test equipment