2. Getting involved
3. Standards Committees
4. NAWGL

DIN Standards Committee Rolling Bearings and Plain Bearings

Overview

This standard specifies dimensions and symbols for single direction thrust ball bearings with flat housing washers, crowned housing washers and with support washers. In consideration of the general plan of boundary dimensions stated in DIN 616 and ISO 104, it offers an adjusted selection of thrust ball bearings with flat housing washers and in addition a similar range of design with crowned housing washers and with support washers for the practical needs of the user. This standard has been prepared by Working Committee NA 118-01-02 AA "Kugellager und Spannlager einschließlich Teile, allgemeines Wälzlagerzubehör und Gehäuse" ("Ball bearings and inside bearings, including parts, general rolling bearings accessories and housings"). With respect to DIN 711:1988-02, the following changes have been made: a) The standard has been completely revised; b) amendments in Table 1: 1) line 511: d = 360 mm has been increased to d = 560 mm; 2) line 514: d = 360 has been reduced to d = 180 mm; amendments in Table 2: 1) line 532: d = 360 mm has been reduced to d = 190 mm; 2) line 533: d = 200 mm has been reduced to d = 150 mm; 3) line 534: d = 180 mm has been reduced to d = 100 mm; d) The figures relating to mass have been deleted in Tables 1 and 2; e) The normative references have been updated.

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 118-01-02 AA - Ball bearings and Insert bearings, including parts, general rolling bearing supplies and housings