NA 152

DIN Standards Committee Technical Fundamentals

Project

Geometrical product specifications (GPS) - Dimensional measuring equipment - Part 1: Plain limit gauges of linear size

Abstract

ISO 1938-1:2015 specifies the most important metrological and design characteristics of plain limit gauges of linear size. ISO 1938-1:2015 defines the different types of plain limit gauges used to verify linear dimensional specifications associated with linear size. ISO 1938-1:2015 also defines the design characteristics and the metrological characteristics for these limit gauges as well as the new or wear limits state Maximum Permissible Limits (MPLs) for the new state or wear limits state for these metrological characteristics. In addition, ISO 1938-1:2015 describes the use of limit gauges. It covers linear sizes up to 500 mm.

Begin

2023-10-04

WI

00290262

Planned document number

DIN EN ISO 1938-1 rev

Project number

15202880

Responsible national committee

NA 152-03-02-07 UA - Length checking practice except coordinate, form and surface measuring technology as well as characteristics of screw threads  

Responsible european committee

CEN/TC 290 - Dimensional and geometrical product specification and verification  

Responsible international committee

ISO/TC 213/WG 6 - General requirements for geometrical product specification (GPS) measuring equipment  

previous edition(s)

Geometrical product specifications (GPS) - Dimensional measuring equipment - Part 1: Plain limit gauges of linear size (ISO 1938-1:2015); German version EN ISO 1938-1:2015
2016-03

Order from DIN Media

Contact

Felix Kaulfersch

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2885
Fax: +49 30 2601-42885

Send message to contact