2. Getting involved
3. Standards Committees
4. FSF

DIN Standards Committee Railway

Abstract

This document describes the state of knowledge resulting from Urban Rail experiences regarding the design of the axle, and further steps to be investigated. CEN-CENELEC Guide 26 from 1st of June 2013 defines Urban Rail Systems. This document: - is applicable for the assessment of new axle designs for urban rail vehicles; - defines EN 13103-1 as basic calculation method ; - defines the calculation procedure of an operational index depending on track layout, payload, mileage, position of the wheelset axle in vehicle. This procedure is based on the examination of Europe-wide service experiences and calculations made on urban rail wheelset axles running in Germany ; - defines the conditions, reflected in this operational index, under which additional assessment steps may be needed; - defines these additional assessment steps, including measurements of bending and torsion moments to derive load collectives representative of normal in-service operating conditions and the determination of equivalent stresses. The design methodologies described in this document have been determined for axles of urban rail rolling stocks running under normal European conditions. If there is any doubt as to whether the railway operating conditions are normal, these methodologies will be adapted. This document applies to: - axles defined in EN 13261:2024; - axles with outboard bearings; - powered and non-powered axles; - solid and hollow axles; - all track gauges . This document does not apply to tilting vehicles. The calculation of wheelset axles for special applications (e.g. tamping/lining/levelling machines) may be made according to this document only for the load cases of free-running and running in train formation. This document does not apply to workload cases. They are calculated separately.

Begin

2021-11-30

WI

00256A4F

Planned document number

DIN CEN/TS 13103-3

Project number

08701508