DIN Standards Committee Nonferrous Metals
DIN EN 12167
Copper and copper alloys - Profiles and bars for general purposes; German version EN 12167:2011
Kupfer und Kupferlegierungen - Profile und Rechteckstangen zur allgemeinen Verwendung; Deutsche Fassung EN 12167:2011
Overview
The standard DIN EN 12167 specifies the composition, property requirements and dimensional tolerances for copper alloy profiles including L-, T-, U-shaped cross-sections, and bars, finally produced by drawing or extruding. This European Standard applies to profiles with L-, T- and U-shaped cross-sections which would fit within a circumscribing circle of a maximum 180 mm diameter and to bars with thicknesses from 3 mm up to and including 60 mm and with widths from 6 mm up to and including 120 mm. The sampling procedures, the test methods for verification of conformity to the requirements of this standard, and the delivery conditions are also specified. The European Standard has been prepared by CEN/TC 133 "Copper and copper alloys" (secretariat: DIN). Regarding German collaboration, the responsible Committee is Working Committee NA 066-02-04 AA "Strangpress- und Zieherzeugnisse" ("Extruded and drawn products") at FNNE.
Document: references other documents
Document: referenced in other documents
Responsible national committee
NA 066-02-04 AA - Extruded and drawn products
Responsible european committee
CEN/TC 133/WG 4 - Extruded and drawn products, forgings and scrap
