DIN Standards Committee Iron and Steel
Flat products made of steels for pressure purposes - Part 3: Weldable fine grain steels, normalized
Abstract
This European Standard specifies requirements for flat products for pressure equipment made of weldable fine grain steels as specified in Table 1. NOTE 1 Fine grain steels are understood as steels with a ferritic grain size of 6 or finer when tested in accordance with EN ISO 643. The requirements and definitions of EN 10028-1:2017 also apply. NOTE 2 Once this European Standard is published in the EU Official Journal (OJEU) under Directive 2014/68/EU, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 2014/68/EU is limited to technical data of materials in this European Standard (Part 1 and the other relevant part of the series) and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of Directive 2014/68/EU are satisfied, needs to be done.
Begin
2025-11-14
WI
EC107068
Planned document number
prEN 10028-3 rev
Responsible national committee
NA 021-00-04-02 UA - Steels for pressure purposes
Responsible european committee
CEN/TC 459/SC 7/WG 1 - Revision of EN 10028-2 to -6 and EN 10207
previous edition(s)
Flat products made of steels for pressure purposes - Part 3: Weldable fine grain steels, normalized
2017-07
