2. Getting involved
3. Standards Committees
4. DKE

DKE German Commission for Electrical, Electronic & Information Technologies of DIN and VDE

Overview

Whereas Part 1 of the series DIN EN 62751 describes the general principles for calculating the power losses in the converter valves independent of the converter topology, this Part 2 contains the detailed method to be adopted for calculating the power losses in the valves for an HVDC system based on the “modular multi-level converter”, where each valve in the converter consists of a number of self-contained, two-terminal controllable voltage sources connected in series. It is applicable both for the cases where each modular cell uses only a single turn-off semiconductor device in each switch position, and the case where each switch position consists of a number of turn-off semiconductor devices in series (topology also referred to as "cascaded two-level converter"). The main formulae are given for the two-level “half-bridge” configuration but guidance is also given in Annex A as to how to extend the results to certain other types of MMC building block configuration. The standard is written mainly for insulated gate bipolar transistors (IGBTs) but may also be used for guidance in the event that other types of turn-off semiconductor devices are used. Power losses in other items of equipment in the HVDC station, apart from the converter valves, are excluded from the scope of this standard. This standard does not apply to converter valves for line-commutated converter HVDC systems. The responsible committee is DKE/K 331 "Leistungselektronik" ("Power electronics") of the DKE (German Commission for Electrical, Electronic and Information Technologies) at DIN and VDE.

Document: references other documents

Responsible national committee

DKE/K 331 - Leistungselektronik