Involute splines based on reference diameters - Part 1: Generalities
Abstract
Kurzreferat (EN), mehr als 100 Zeichen, max. 640 Zeichen This document applies to involute spline connections with reference diameters for the detachable, sliding or fixed connection of shaft and hub and defines certain principles for this. A uniform pressure angle of 30°, the same reference profile for all pitches, flank centering and the use of profile offsets to achieve specific reference diameters apply. The fit system contains tolerances for the effective form deviations, so that their influence on the fit clearance is taken into account. All requirements are taken into account by the possible selection of different dimensional series and tolerance classes.
Begin
2022-04-20
Planned document number
DIN 5480-1
Project number
06004146
Responsible national committee
previous edition(s)
Involute splines based on reference diameters - Part 1: Generalities
2006-03