• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Project

Gas-fired endothermic engine driven heat pumps - Part 2: Safety; German and English version prEN 16905-2:2022

Abstract

1.1 Scope of prEN 16905This European Standard specifies the requirements, test methods and test conditions for the rating and performance calculation of air conditioners and heat pumps using either air, water or brine as heat transfer media, with gas-fired endothermic engine driven compressors when used for space heating, cooling and refrigeration, hereafter referred to as "GEHP appliance".This European Standard only applies to GEHP appliances with a maximum heat input (based on net calorific value) not exceeding 70 kW at standard rating conditions.This standard only applies to GEHP appliances under categories I2H, I2E, I2Er, I2R, I2E(S)B, I2L, I2LL, I2ELL, I2E®B, I2ESi, I2E®, I3P, I3B, I3B/P, II2H3+, II2Er3+, II2H3B/P, II2L3B/P, II2E3B/P, II2ELL3B/P, II2L3P, II2H3P, II2E3P and II2Er3P according to EN 437:2003+A1:2009.This standard only applies to GEHP appliances having:a) gas fired endothermic engines under the control of fully automatic control systems;b) closed system refrigerant circuits in which the refrigerant does not come into direct contact with the fluid to be cooled or heated;c) where the temperature of the heat transfer fluid of the heating system (heating water circuit) does not exceed 105 ºC during normal operation;d) where the maximum operating pressure in the1) heating water circuit (if installed) does not exceed 6 bar2) domestic hot water circuit (if installed) does not exceed 10 bar.This European Standard applies to GEHP appliances only when used for space heating or space cooling or for refrigeration, with or without heat recovery.The GEHP appliances having their condenser cooled by air and by the evaporation of external additional water are not covered by this European Standard.Packaged units, single split and multisplit systems are covered by this European Standard. Single duct and double duct units are covered by this European Standard.The above GEHP appliances can have one or more primary or secondary functions.This European Standard is applicable to GEHP appliances that are intended to be type tested. Requirements for GEHP appliances that are not type tested would need to be subject to further consideration.In the case of packaged units (consisting of several parts), the standard applies only to those designed and supplied as a complete package.NOTE All the symbols given in this text are used regardless of the language used.1.2 Scope of prEN 16905-2This part of prEN 16905 specifies the safety requirements, the safety test conditions and the safety test methods of gas-fired endothermic engine driven heat pumps for heating and/or cooling mode including the engine heat recovery.

Begin

2020-10-19

WI

00299036

Planned document number

DIN EN 16905-2

Project number

03200889

Responsible national committee

NA 032-03-01-06 AK - Gas-fired sorption appliances, indirect fired sorption appliances, gas-fired endothermic engine heat pumps and domestic gas-fired washing and drying appliancees  

Responsible european committee

CEN/TC 299/WG 3 - Gas-fired endothermic engine heat pumps  

draft standard

Gas-fired endothermic engine driven heat pumps - Part 2: Safety; German and English version prEN 16905-2:2021
2022-01
Order from DIN Media

previous edition(s)

Gas-fired endothermic engine driven heat pumps - Part 2: Safety; German version EN 16905-2:2020
2020-03

Order from DIN Media

Contact

Sophia Hayen

Josef-Wirmer-Str. 1 - 3
53123 Bonn

Tel.: +49 228 9188-230

Send message to contact