• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Project

Static thermoplastic tanks for above ground storage of liquid fuels at atmospheric pressure - Product characteristics and test methods

Abstract

This European Standard specifies procedures for assessments and verification of constancy of performance of static thermoplastic tanks in relation to their characteristics and they are intended to be used for internal and/or external installations, for above ground storage of fuels. This European Standard covers the following static thermoplastic tanks, either with or without factory assembled reinforcement, that are made of:  blow moulded polyethylene (BM), or  rotationally moulded polyethylene (RM), or  rotationally moulded anionically polymerized polyamide 6 (PA) . With regard to the intended use, this European Standard covers the following fuel:  kerosene,  heating oil,  diesel,  biofuels. This European Standard covers static blow moulded and rotationally moulded polyethylene tanks and rotationally moulded tanks made of anionically polymerized polyamide 6 with maximum filling capacity (see 3.5) from 400 l up to and including 10 000 l. This European Standard does not cover: a) static thermoplastic tanks (blowmoulded and rotationally moulded) manufactured using recycled thermoplastic material (see 3.6), b) rotationally moulded static thermoplastic tanks manufactured using regrind thermoplastic material (see 3.7), c) blow moulded static thermoplastic tanks manufactured using more than 50 % of regrind thermoplastic material (see 3.8), d) static thermoplastic tanks that are intended to be used for the transport and distribution of fuels or gasses, or tanks for the storage of gas.

Begin

2022-10-06

WI

00249A2C

Planned document number

DIN EN 13341 rev

Project number

10400364

Responsible national committee

NA 104-01-04 AA - Thermoplastic tanks  

Responsible european committee

CEN/TC 249/WG 25 - Static thermoplastic tanks for above ground storage of fuel  

previous edition(s)

Static thermoplastic tanks for above ground storage of domestic heating oils, kerosene and diesel fuels - Blow moulded and rotationally moulded polyethylene tanks and rotationally moulded tanks made of anionically polymerized polyamide 6 - Requirements and test methods; German version EN 13341:2005+A1:2011
2011-04

Order from DIN Media

Contact

Peer Schrapers

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2711
Fax: +49 30 2601-42711

Send message to contact