Overview

This test standard describes two categories of pressure impulse tests without flexing for rubber and plastic hydraulic hoses and hose assemblies. Category 1 is a high pressure test for test pressures greater than 3 MPa and Category 2 is for test pressures from 1.5 to 3 MPa. This test is applicable to hydraulic hose assemblies that are subjected to pulsating pressure during operation and which are within the product requirements. This document has been prepared by Technical Committee ISO/TC 45 "Rubber and rubber products" in collaboration with Technical Committee CEN/TC 218 "Rubber and plastics hoses and hose assemblies". The responsible national standardization committee is Working Committee NA 045-02-12 AA "Gummi- und Kunststoffschläuche sowie Schlauchleitungen (Spiegelgremium zu CEN/TC 218, ISO/TC 45/SC 1)" ("Rubber and plastics hoses and hose assemblies (national mirror committee for CEN/TC 218, ISO/TC 45/SC 1)") at DIN Standards Committee Elastomer Technology (NET).

Document: references other documents

Responsible national committee

NA 045-02-12 AA - Rubber and plastics hoses and hose assemblies (Mirror committee to CEN/TC 218; ISO/TC 45/SC 1)  

Responsible european committee

CEN/TC 218 - Rubber and plastics hoses and hose assemblies  

Responsible international committee

ISO/TC 45/SC 1/WG 4 - Hose test methods