Overview

This International Standard applies to the suspension parts of electroacoustic transducers (for example, loudspeakers). It defines the parameters and measurement methods to determine the properties of suspension parts like spiders, surrounds, diaphragms or cones before being assembled in the transducer. Static and dynamic methods have been developed for measuring the suspension parts at small and high amplitudes. Due to the visco-elastic properties of the suspension material (fabric, rubber, foam, paper) the measurement results depend on the measurement conditions and are not comparable between different methods. For example, the properties measured by static method significantly deviate from the dynamic behaviour of the suspension material when excited by an audio signal. The measurement results are needed for engineering design purposes and for quality control. Furthermore, this method is intended to improve the correlation of measurements between suspension-part manufacturers and loudspeaker manufacturers. Corrigendum 1 presented here contains corrections to the calculation of the lowest resonant frequency and other error corrections. The responsible committee is UK 742.5 "Lautsprecher" ("Loudspeakers") of the DKE (German Commission for Electrical, Electronic and Informational Technologies) at DIN and VDE.

Document: references other documents

Responsible national committee

DKE/UK 742.5 - Lautsprecher  

Responsible international committee

IEC/TC 100 - Audio, video and multimedia systems and equipment