• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Standards [CURRENT]

DIN EN ISO 25178-605
Geometrical product specifications (GPS) - Surface texture: Areal - Part 605: Nominal characteristics of non-contact (point autofocus probe) instruments (ISO 25178-605:2014); German version EN ISO 25178-605:2014

Title (German)

Geometrische Produktspezifikation (GPS) - Oberflächenbeschaffenheit: Flächenhaft - Teil 605: Merkmale von berührungslos messenden Geräten (Punkt-Autofokus-Sensor) (ISO 25178-605:2014); Deutsche Fassung EN ISO 25178-605:2014

Overview

This part of ISO 25178 is a Geometrical Product Specification (GPS) standard and is to be regarded as a General GPS standard (see ISO/TR 14638). It influences the chain link 5 of the chains of standards on roughness profile, waviness profile, primary profile, and areal surface texture. The ISO/GPS Masterplan given in ISO/TR 14638 gives an overview of the ISO/GPS system of which this standard is a part. The fundamental rules of ISO/GPS given in ISO 8015 apply to this standard. The default decision rules given in ISO 14253-1 apply to specifications made in accordance with this standard, unless otherwise indicated. The point autofocus optical principle can be implemented in various set-ups. The configuration described in this document comprises three basic elements: an autofocus optical system, an autofocus mechanism, and an electronic controller. This type of instrument is mainly designed for areal measurements, but it is also able to perform profile measurements. This part of ISO 25178 describes the metrological characteristics of an optical profiler using a point autofocus probe for the measurement of areal surface texture. This document (EN ISO 25178-605:2014) has been prepared by Technical Committee ISO/TC 213 "Dimensional and geometrical product specifications and verification" (secretariat: DS, Denmark) in collaboration with Technical Committee CEN/TC 290 "Dimensional and geometrical product specification and verification" the secretariat of which is held by AFNOR (France). The responsible national body involved in its preparation was Working Committee NA 152-03-03 AA "Oberflächen" ("Surfaces") at DIN Standards Committee Technical Fundamentals (NATG).

Document: references other documents

Responsible national committee

NA 152-03-03 AA - Surfaces  

Responsible european committee

CEN/TC 290 - Dimensional and geometrical product specification and verification  

Edition 2014-06
Original language German
Translation English
Price from 112.30 €
Table of contents

Contact

Felix Kaulfersch

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2885
Fax: +49 30 2601-42885

Send message to contact