• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Technical Report [CURRENT]

DIN CEN/TR 16324 ; DIN SPEC 10624:2012-11
Technical report of the interlaboratory study for the determination of Besatz in common wheat, rye and durum wheat; German version CEN/TR 16324:2012

Title (German)

Technischer Bericht über Ringversuchsergebnisse zur Bestimmung von Besatz in Weizen, Roggen und Hartweizen; Deutsche Fassung CEN/TR 16324:2012

Procedure

Technical Report

Overview

This Technical Report DIN CEN/TR 16324 (DIN SPEC 10624) contains the preparation and evaluation of the results of an international interlaboratory test for standard DIN EN 15587 "Cereals and cereal products - Determination of Besatz in wheat (Triticum aestivum L.), durum wheat (Triticum durum Desf.), rye (Secale cereale L.) and feed barley (Hordeum vulgare L.)". The term "Besatz" applies to all components of a grain sample that differ from the normal basic cereal. It includes the following groups: broken grains, shrivelled grains, other cereals, grains damaged by pests, grains with discoloured germ, grains overheated during drying, sprouted grains, extraneous seeds, unsound grains, ergot, bunted grains, extraneous matter, husks and impurities of animal origin. The amount of Besatz and its constituent groups is important for health, cleaning, milling and further processing aspects. For these reasons Besatz is a component of contracts in grain trade and also of the grain intervention system of EU. The principle of the determination of Besatz is to separate all the groups of Besatz from the normal basic cereal grains of unimpaired quality by sieving and manual selection out of a subsample and to quantify them. There are various problems in the determination of Besatz: Firstly, the identification of the different groups of Besatz depends strongly on the experience and the knowledge of the investigator. Also experienced investigators can differ in their characterization of grains. Finally, one is faced with the fact that grain, even after mixing, is rarely homogenous. In other words, if a sample was divided by a sample divider into a number of portions, the amount of a specific group of Besatz in each portion could be different, even if absolutely no human or machine error occurred in each determination. These problems will result in variation of the results of the determination. An international interlaboratory trial for the determination of Besatz in common wheat, durum wheat and rye was accomplished with 15 laboratories in order to get information on the intra- and interlaboratory variability of the determination of Besatz. This Technical Report here describes the preparation and evaluation of the results of this interlaboratory test. Committee NA 057-05-06 AA "Getreide und Getreideerzeugnisse" ("Cereal and cereal products") at DIN is responsible for this Technical Report.

Document: references other documents

Responsible national committee

NA 057-05-06 AA - Cereals and cereal products  

Responsible european committee

CEN/TC 338 - Cereal and cereal products  

Edition 2012-11
Original language German
Price from 130.70 €
Table of contents

Contact

Konstantina Döhring

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2434
Fax: +49 30 2601-42434

Send message to contact