• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Standards [CURRENT]

DIN 9830
Burr heights on stamped parts

Title (German)

Schnittgrathöhen an Stanzteilen

Overview

This standard is the technical revision of the standard which has been published in 2010-01. The clauses "Normative references" and "Terms and definitions" as well as a new figure have been included in this revision. Furthermore, a note has been added in Table 1. This standard specifies burr heights ranges in dependence on the tensile strength of the material and the thickness of the workpiece and allocates them to various accuracy levels. This standard has been prepared by NA 026-00-03 AA "Stanzteile" ("Stamped parts") of the Springs, Stamped Parts and Moulded Parts Standards Committee (NAFS) at DIN, the German Institute for Standardization e. V. For further information about the NAFS, visit us on the Internet under www.nafs.din.de.

Document: references other documents

Responsible national committee

NA 026-00-03 AA - Stamped Parts  

Edition 2011-10
Original language German
Translation English
Price from 34.60 €
Table of contents

Contact

Katharina Lachmann

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2450
Fax: +49 30 2601-42450

Send message to contact