DIN Standards Committee Welding and allied processes
Gas welding equipment - Manual gas equipment for welding, heating and cutting - Periodic inspection
Abstract
This document specifies guidelines for periodic inspections of gas equipment for welding, cutting and allied processes placed downstream of the gas cylinder's valve as shown in Figure 1 or, in the case of centralized distribution, downstream from the tapping point, since commissioning. NOTE In some cases, gas cylinders can be replaced by cylinder bundles. Acetylene cylinder bundle systems upstream of the tapping point are excluded. This document applies to gas welding equipment intended for professional use which utilizes compressed gases up to 300 bar (30 MPa), acetylene, liquefied petroleum gas (LPG), methylacetylene-propadiene mixtures (MPS) and carbon dioxide (CO2) and related mixtures. This document does not apply to automatic applications of gas welding, cutting and allied processes.
Begin
2021-03-19
WI
00121894
Planned document number
FprEN 17931
Responsible national committee
NA 092-00-07 AA - Equipment for gas welding, cutting and allied processes
Responsible european committee
CEN/TC 121/WG 19 - Equipment for gas welding, cutting and allied processes
draft standard
Gas welding equipment - Manual gas equipment for welding, heating and cutting - Periodic Inspection
2023-02
Order from DIN Media
Gas welding equipment - Manual gas equipment for welding, heating and cutting - Periodic inspection
2025-10
Order from DIN Media
