• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Project

Helical springs made of round wire and rod - Part 3: Information to be given in order to obtain the hot formed compression spring required, printed form C

Abstract

This document is applicable for hot formed helical compression springs made from wire and bar. It specifies a form in A4 format according to DIN EN ISO 216 for the information to be supplied on these compression springs. NOTE If compression springs made of sectional steels cannot be avoided in special cases, e.g. for installation reasons, it is necessary to consult the spring manufacturer. The form can then be completed according to corresponding agreements about design and permissible deviations.

Begin

2024-04-16

Planned document number

DIN 2099-3

Project number

02600104

Responsible national committee

NA 026-00-01 AA - Springs  

previous edition(s)

Helical springs made of round wire and rod - Part 3: Information to be given in order to obtain the hot formed compression spring required, printed form C
2004-05

Order from DIN Media

Contact

Katharina Lachmann

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2450
Fax: +49 30 2601-42450

Send message to contact