• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Project

Fasteners - Reverse-taper grooved pins - One quarter-length progressive grooves on both sides (ISO/DIS 13670:2023); German and English version prEN ISO 13670:2023

Abstract

This document specifies the characteristics of grooved reverse-taper pins with one quarter-length progressive grooves on both sides (close-ends), with rounded or chamfered pin ends, in steel and stainless steel, with nominal diameters 2 mm to 25 mm. These grooved pins are designed to fulfil the main following functions: - relative rotation of the assembled parts, - locking of two (or more) parts, - positioning. The general requirements (including principles for grooved pins and assembly) are specified in ISO 13669.

Begin

2023-05-05

WI

00185438

Planned document number

DIN EN ISO 13670

Project number

06702415

Responsible national committee

NA 067-00-10 AA - Pins, Rivets  

Responsible european committee

CEN/TC 185 - Fasteners  

Responsible international committee

ISO/TC 2/WG 13 - Washer and non-threaded fasteners  

draft standard

Fasteners - Reverse-taper grooved pins - One quarter-length progressive grooves on both sides (ISO/DIS 13670:2023); German and English version prEN ISO 13670:2023
2024-01
Order from DIN Media

Contact

Dipl.-Ing. (FH)

Holger Zernitz

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2051
Fax: +49 30 2601-42051

Send message to contact