• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information

Hot rolled steel channels, I and H sections - Dimensions and masses


This European standard specifies the nominal dimensions and masses of the hot rolled steel channels, I and H sections. The following shapes are covered by this standard: Sections: - Parallel flange I sections IPE; - Wide flange beams HE; - Extra wide flange beams HL and HLZ; - Wide flange columns HD; - Wide flange bearing piles HP and UBP; - Universal beams UB; - Universal columns UC; - Taper flange I sections IPN and J. Channels: - Parallel flange channels UPE and PFC; - Taper flange channels UPN, U and CH. These requirements do not apply to hot rolled steel channels, I and H sections from stainless steel.





Planned document number

DIN EN 10365 rev

Project number


Responsible national committee

NA 021-00-21-06 UA - Hot-rolled sections  

Responsible european committee

CEN/TC 459/SC 3/WG 6 - Dimensional standards for open sections  

previous edition(s)

Hot rolled steel channels, I and H sections - Dimensions and masses; German version EN 10365:2017

Order from DIN Media



Robert Orosz

Sohnstr. 65
40237 Düsseldorf

Tel.: +49 211 6707-303

Send message to contact