2. Getting involved
3. Standards Committees
4. NPS

DIN Standards Committee Personal Protective Equipment

Abstract

This document is intended to amend DIN EN ISO 21420:2020-06. DIN EN ISO 21420:2020-06 specifies the general requirements and relevant test procedures for glove design and construction, innocuousness, comfort and efficiency, as well as the marking and information supplied by the manufacturer applicable to all protective gloves. It can also apply to arm protectors and gloves permanently incorporated in containment enclosures. Gloves and hand protectors such as mittens, pot holders and arm protection are covered by this document. This document does not address the protective properties of gloves and therefore is not used alone but only in combination with the appropriate specific standard(s). A non-exhaustive list of these standards is given in the Bibliography.

Begin

2021-06-21

WI

00162463

Planned document number

DIN EN ISO 21420/A1

Project number

07500595

Responsible national committee

NA 075-05-08 AA - Protective gloves  

Responsible european committee

CEN/TC 162/WG 8 - Protective gloves  

Responsible international committee

ISO/TC 94/SC 13/WG 8 - Standardization for protective gloves  

draft standard

Protective gloves - General requirements and test methods - Amendment 1 (ISO 21420:2020/DAM 1:2021); German and English version EN ISO 21420:2020/prA1:2021
2021-11
Order from DIN Media

previous edition(s)

Protective gloves - General requirements and test methods (ISO 21420:2020); German version EN ISO 21420:2020
2020-06