NA 032

DIN Standards Committee Gas Technology

Project

Hose assemblies for stainless steel for gas — Connections

Abstract

This document specifies the permitted national connections for hose assemblies according to DIN EN 16617 for gases of the second and third families according to DIN EN 437 and DVGW G 260 (but not for liquefied gas in the liquid phase) with a nominal diameter up to and including DN 300 and a maximum permissible operating pressure less than or equal to 1.6 MPa (16 bar). NOTE: It is advised that for gas hose assemblies according to this standard, which are intended for a MOP of more than 500 hPa (0.5 bar), the applicable regulations of the Pressure Equipment Directive 2014/68/EU must be fulfilled. The revision is based on DIN 3384:2007-08. All requirements and tests that are specified in DIN EN 16617:2015-07 have been deleted in the present document and supplemented by connections that are not listed in DIN EN 16617:2015-07.

Begin

2022-01-20

Planned document number

DIN 3384

Project number

03200954

Responsible national committee

NA 032-03-02 AA - Components and auxiliary supplies - Gas 

Contact

Dipl.-Ing.

Holger Stange

Josef-Wirmer-Str. 1 - 3
53123 Bonn

Tel.: +49 228 9188-8862

Send message to contact