2. Getting involved
3. Standards Committees
4. NABau

DIN Standards Committee Building and Civil Engineering

Abstract

This standard specifies edge shapes of flat glass for use in construction and their types of execution. They apply to - float glass; - ornamental glass; - drawn flat glass; - wired ornamental glass; - wire mirror glass. Edges of drilled holes are not covered by this standard. NOTE The edge processing of toughened and partially toughened flat glass products as well as laminated glass and laminated safety glass is regulated in the corresponding product standards.

Begin

2022-09-28

Planned document number

DIN 1249-11

Project number

00519453

Responsible national committee

NA 005-09-29 AA - Glass in building (national mirror committee (SpA) to CEN/TC 129 and ISO/TC 160; SpA to CEN/TC 129 and ISO/TC 160; SpA to CEN/TC 129/WG 1, CEN/TC 129/WG 2, CEN/TC 129/WG 3, CEN/TC 129/WG 5, CEN/TC 129/WG 6, CEN/TC 129/WG 8, CEN/TC 129/WG 9, CEN/TC 129/WG 10, CEN/TC 129/WG 12, CEN/TC 129/WG 14, CEN/TC 129/WG 17, CEN/TC 129/WG 18, CEN/TC 129/WG 19, CEN/TC 129/WG 20, CEN/TC 129/WG 21, ISO/TC 160/CAG, ISO/TC 160/WG 1, ISO/TC 160/WG 2, ISO/TC 160/WG 3, ISO/TC 160/WG 4, ISO/TC 160/WG 5, ISO/TC 160/WG 7, ISO/TC 160/WG 8, ISO/TC 160/WG 9, ISO/TC 160/WG 10)  

draft standard

Glass in building - Part 11: Glass edges - Terms and definitions, characteristics of edge types and finishes
2023-09
Order from Beuth Verlag

Glass in building - Part 11: Glass edges - Terms and definitions, characteristics of edge types and finishes
2024-05
Order from Beuth Verlag

previous edition(s)

Glass in building - Part 11: Glass edges - Terms and definitions, characteristics of edge types and finishes
2017-05