2. Getting involved
3. Standards Committees
4. NATG

DIN Standards Committee Technical Fundamentals

Overview

This part of ISO 16610 provides methods for treating the end effects of linear profile filters where such effects occur. This part of ISO 16610 is a geometrical product specification (GPS) standard and is to be regarded as a general GPS standard (see ISO 14638). It influences the chain link 3 of all chains of standards. The ISO/GPS Matrix model given in ISO 14638 gives an overview of the ISO/GPS system of which this document is a part. The fundamental rules of ISO/GPS given in ISO 8015 apply to this document and the default decision rules given in ISO 14253-1 apply to specifications made in accordance with this document, unless otherwise indicated. This document (prEN ISO 16610-28:2015) has been prepared by Technical Committee ISO/TC 213 "Dimensional and geometrical product specifications and verification" (secretariat: DS, Denmark) in collaboration with Technical Committee CEN/TC 290 "Dimensional and geometrical product specification and verification", the secretariat of which is held by AFNOR (France). The responsible national committee is Working Committee NA 152-03-03 AA "Oberflächen" ("Surfaces") at DIN Standards Committee Technical Fundamentals (NATG).

Document: references other documents

Responsible national committee

NA 152-03-03 AA - Surfaces  

Responsible european committee

CEN/TC 290 - Dimensional and geometrical product specification and verification  

Responsible international committee

ISO/TC 213/WG 15 - GPS extraction and filtration techniques